Search

[ToyDemon]

Advance Modding and Fixing Onaholes

The following is for advance modding intended for people who feels comfortable with -
a) Using any of the tools needed in a safe and professional matter.
b) The fact that their onahole could be damaged and destroyed in a unrecoverable manner by these procedures.

While also agreeing to the following -
a) Always wear any safety eyewear, gloves and clothing when working with the needed tools.
b) Always work in a safe, brightly lit, and well ventilated area.
c) Always test the procedure out on a small piece of sample material before doing anything to the whole onahole.
d) As stated in the DIY area, these posts are offered as tips and we are not endorsing these procedures or responsible for them. It is up to the discretion and risk of the user if they are to use anything here.


The basic tool you'll need in the mod will be a soldering iron

If you are asking what this is or where you can buy one, this post is probably not for you.

The male products we carry are mostly silicone products. As such it is possible to melt the material with a soldering iron so you should know where this is going.

Fixing holes

So there magically is a hole in your onahole 

Instead of throwing it away, let's fix it.


We'll need material to patch it with. Cut a useless corner of the onahole for transplant.


Place the material in the hole and solder away


Good as new almost


Making a non-through hole out of a through hole

Very similar to the patching


A through hole or ripped hole.


Solder away at it safely.


Everything good to go.


Getting creative with this mod


Two through holes become one modded long one.


Strength test, looks good


Cut and seal one end to make it a long non-through hole


Your very own custom non-through onahole


We hope this information is helpful to everyone. Let us know what you think about this post.
We would love to see your very own mods and more but remember to be safe.

[HardGay]

Niiiiice!!!! sodering iron is a must i suppose for everyone who have a minor rip on their toy. thanks for the post

[Sevenfold]

what about fixing Meiki products? Is it possible to use the same method?

[ToyDemon]

Meiki can be fixed also with this method.

[billyjoe]

ha!  That's the Aura 2 shown with the rip.  Is this the reason TD doesn't offer this particular model, or is it just that the original Aura tested better?

[Zeke]

Yo! you guys! ive tried a few of these repairs on my Qyu Qyu Sprial and i burned the SHIT!!! out of my finger in the process. The material was jumping around and got me but it was worth it apparently because i fixed it using a butter knife (that was put aside as a spare witch is now for repairs ) by putting the hot knife in between the tear and let it melt shut wile pulling it out kinda slow and smoothened out the excess melted material. so it was then fixed so i tried it out and it ripped in the same spot so i did it again but i did a better job this time around because it worked after trying it again but it ripped a little on the opposite side this time around BUT as a plus from sticking the knife into the thing i started to deform the passageway and i noticed that the entrance of it felt...BETTER! it felt pretty good! so apparently theres an added bonus to the passage deforming!   i guess i may learned something by burning my finger that may be of use to us all.

[CulturedSwine69]

I have a tear on my Manbow toy, would this method work also? I wanna know since the material is the "baby skin"

[ToyDemon]

Yes it will work for Manbow

[tdlordz]

I've had good luck using this method to repair my meiki zxy which has a tendency to tear. Remember to solder in a well ventilated place!