Search

[zamentor]

I'd like to share the results of engineering research and design of my perfect masturbation station. Photos are attached and I'll also describe what this is.

The first step is to cut an eight-inch section of a four-inch diameter PVC water pipe and then cut this lengthwise in half to create a support channel. I then attach the pipe to a two-foot piece of wood using short wood screws. This provides stability. I then tape the entire construction to a table so that when I straddle it, my scrotum is about 3 inches above the pipe.

Next I create the ball and scrotum fondler by inverting a regular masturbation sleeve and dousing it with Goof-Off. The Goof-Off will wrinkle and contort the masturbation sleeve to create a highly textured surface for amazing stimulation. Wash several times thoroughly to remove any residual Goof-Off and allow the prepared sleeve to dry. I put it in the sun and that seems to clear any remaining fumes.

The sleeve is now placed in the prepared channel and a Meiki Extreme Pleasure Hip (my all-time favorite thing) strategically positioned at the end of the inverted sleeve ready for penetration.

Lube everything thoroughly and prepare to be blown away. I like to keep a trigger-action water sprayer handy to re-moisten the working surface from time to time.

[Timmy Tucker]

I applaud your creativity. You seem to be quite dedicated to tinkering with what you have to get it exactly to your tastes. Keep up the great work!