Search

[BigDog]

I have seen the question asked several times, and I am sure most of us have our own devised ways for keeping the inside of an onahole clean after use - especially for ones that are long, have lots of internal textures, and can not be turned inside out.

I have found a few products, and I will post to TD in the "Suggestions" forum topic as well.

Basically you can use a specialty nozzle on a re-useable bottle - the ones I have seen however do not appear to be long enough for some of the onaholes.  The other possibility is the portable bidit / personal hygene products designed for cleaning - with a nozzle that is quite long.

I am not endorsing any one product, or site from which to order, only listing a few I have found while doing a search - use the keywords to locate something like these from the site of your choice.  I as noted, I will suggest to TD as well and perhaps they can offer items of this nature so we can have the one stop shopping for all of our onahole needs.

Here is what I have found (read their reviews and dimension as applicable for your needs and or cautions):

Plus+Size Living Brylanehome Personal Hygiene Refresher   -


Portable wash buttocks soft BB-317 (japan import)   -   


Boulder Bidet - Portable Travel Hiking Backpacking Bidet   -   


Brondell GS-70 GoSpa Travel Bidet   -   


Super Wash Masturbator Cleaning Nozzle   -   

[quake3guy]

I see this post was moved to the "How-To" section, adding my reply so as to get feedback:

Here is something that seems to work well for any closed-hole device; an idea I had while reading the product description for the "Furi Furi Ona Shaker" at J-List..  Wine Bottle!  They also use a mild detergent, which appears to be analogous to unscented laundry detergent for sensitive skin.

First step, fill an empty/cleaned wine bottle about 1/3 full with filtered water and add a half teaspoon of detergent.  Then with the toy's cavity slightly wet, gently insert the open end of the wine bottle til it will go no further, perhaps wiggling & squishing a little to go further.

Now tilt the two items so the wine bottle is horizontal and shake/rock them in unison from side to side, splashing water deep into the cavity then back into the bottle for a minute or two, progressively retracting the bottle so it exposes more of the cavity wall to this sloshing action.  When the bottle is nearly out of the cavity, turn the two items so the bottle is upside-down above the toy, squeeze/jiggle the toy to work loose any remaining debris, which may visibly float into the bottle against gravity.  Turn the two items so the bottle is now upright and the sudsy water falls out of the toy as you remove the bottle.  Repeat as necessary.

Next, rinse the bottle so there's no detergent left behind, fill it 3/4 with fresh filtered water and repeat the above horizontal sloshing action while progressively retracting the bottle from a fully-inserted position.  This will rinse out the detergent, and you're now ready for drying.

~5 minutes and you're done, No mess!

Does anyone have suggestions for drying though?  I wish there were some kind of glass funnel with rounded edges that would widen the tunnel just enough to allow a cloth or paper towel to be inserted without rubbing anything, then left in place a short while after the funnel is retracted around it..  Ideas?